Position Light - Honda NC700XA Service Manual

dummyhead dummyhead
REAR
Remove the tail light cover (page 2-10).
Remove the turn signal light mounting screw [1], setting
plate [2] and turn signal light [3].
Remove the mounting rubber [4].
Installation is in the reverse order of removal.
Route the wires properly (page 1-25).
TORQUE:
Turn signal light mounting screw:
2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)

POSITION LIGHT

BULB REPLACEMENT (NC700X/XA/
XD)
Pull out the position light bulb socket [1].
Remove the bulb [2] from the socket, replace it with a
new one.
Installation is in the reverse order of removal.
Route the wires properly (page 1-25).
BULB REPLACEMENT (NC700S/SA/
SD)
Remove the headlight/headlight stay (page 2-27).
Pull out the position light bulb socket [1].
Remove the bulb [2] from the socket, replace it with a
new one.
Installation is in the reverse order of removal.
LIGHTS/METERS/SWITCHES
[2]
[1]
[1]
[1]
[4]
[3]
[2]
[2]
22-7