Neutral Switch - Honda 1998 VT750C Service Manual

If the indicator does not come on, inspect as follows:
Remove the left rear cover (page 7-3).
Disconnect the oil pressure switch wire from the
switch by removing the terminal screw.
Short it to ground using a jumper wire. Turn the
ignition switch "ON".
The oil pressure warning indicator should come on.
If the indicator does not come on, check the sub-fuse
(10A) and wires for a loose connection or an open
circuit.
Start the engine and make sure that the indicator goes
out. If the indicator does not go out, check the oil pres-
sure (page 4-3).
Ifthe oil pressure is normal, replace the oil pressure
switch (page 4-3).
NEUTRAL SWITCH
INSPECTION
Remove the right side cover (page 2-4).
Disconnect the engine sub-harness
2P
(Black)
connector.
Shift the transmission into neutral and check for con-
tinuity between the Light green/Red wire and ground.
There should be continuity when the transmission
is in neutral.
There should be no continuity when the transmission
is in any other gear.
REMOVAL/INSTALLATION
Remove the left rear cover (page 7-4).
Disconnect the neutral switch connector.
LIGHTS/METERS/SWITCHES
VT750CD/CD2 (After 2000) :
VT750C3/CD3:
CONNECTOR
19-15