Honda NC700XA Service Manual page 595

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
WHEEL BEARING REPLACEMENT
Install the bearing remover head [1] into the bearing [2].
From the opposite side, install the bearing remover
shaft [3] and drive out the bearing from the wheel hub.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover head, 20 mm
Bearing remover shaft
Drive in a new right side bearing [1] squarely with its
Never install the old
marked side facing up until it is fully seated.
bearing, once the
bearing has been
Install the distance collar.
removed, the
Drive in a new left side bearing squarely with its marked
bearing must be
side facing up until it is seated on the distance collar.
replaced with new
ones.
TOOLS:
Driver [2]
Attachment, 42 x 47 mm [3]
Pilot, 20 mm [4]
INSTALLATION
Install the side collars [1].
Install the front wheel between the fork legs.
Apply a thin coat of grease to the front axle sliding
surface.
Install the front axle [1] from left side.
Tighten the front axle to the specified torque.
TORQUE: 74 N·m (7.5 kgf·m, 55 lbf·ft)
17-24
07746-0050600
07GGD-0010100
[1]
07749-0010000
07746-0010300
07746-0040500
[2]
[1]
[1]
[3]
[2]
[3]/[4]
[1]