Neutral Switch - Honda Shadow TA200 2001 Manual

LIGHTS/METER/SWITCHES
NEUTRAL SWITCH
Disconnect the alternator/neutral switch 4P connector.
Shift the transmission i n to neutral and check for continuity
between the Light Green/Red wire terminal and ground.
There should be continuity with the transmission is in neutral,
and no continuity when the transmission i s into gear.
ALTERNQTORINEUTRAL SWITCH 4P
CONNECTOR
REMOVAL/INSTALLATION
Remove the drive sprocket cover (page 6-3)
Remove the wire cranp plate (page 10-2).
Remove the neutral switch cap and disconnect the neutral
switch wire.
Remove the neutral switch and 0-ring.
Replace the 0-ring and installation is i n the reverse order of
removal.
TIJRNSIGNAL RELAY
REMOVAL/INSTALLATION
Remove the right side cover (page 2-3).
Remove the turn signal relay 2P connector and turn signal
relay.
INSPECTION
Check the following:
- Battery condition
- Burned out turn signal l i ght bulbs or non-specified wattage
- Burned fuse (15 A)
- Ignition switch and turn signal switch function
- Loose connectors
WIRE
JUMPER WIRE
- 0-RING
NEUTRAL SWITCH
TURN SIGNAL RERAY
2P CONNECTOR
]
2P CONNECTOR
If the above items are all normal, check the following:
Disconnect the 2P connector lrom the relay.
Short the Gray and Black terminals of the turn signal relay
connector with a jumper wire.
Turn the i g nition switch ON and check the turn signal light.
Light does not come on:
• Broken wire harness
18-8