Honda NC700XA Service Manual page 666

dummyhead dummyhead
DISASSEMBLY/ASSEMBLY
Disassemble the front brake caliper as following the
illustration.
• Be careful not to damage the piston sliding surface.
• If the caliper pin boot and bracket pin boot are hard
or deteriorated, replace it with a new one.
BLEED VALVE
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
CALIPER BODY
STOPPER RING
BRAKE PAD PIN
17 N·m (1.7 kgf·m, 13 lbf·ft)
BRACKET PIN BOOT
Place a shop towel over the pistons.
Position the caliper body with the pistons down and
Do not use high
apply small squirts of air pressure to the fluid inlet to
pressure air or bring
remove the pistons.
the nozzle too close
to the inlet.
Clean the seal grooves with clean brake fluid.
Assembly is in the reverse order of disassembly.
• Apply locking agent to the caliper pin and bracket
pin threads.
• Replace the piston seals and dust seals with new
ones.
• Apply brake fluid to the caliper pistons and new
piston seals.
• Apply silicone grease to new dust seals.
• Install the pistons with the opening toward the pads.
• Apply Honda Bond A, Cemedine #540 or equivalent
to the brake pad retainer mating surface.
• Apply 0.4 g (0.01 oz) of silicone grease to the caliper
pin and bracket pin sliding surface.
CALIPER PIN BOOT
CALIPER PISTON
DUST SEAL
PISTON SEAL
CALIPER PIN
22 N·m (2.2 kgf·m, 16 lbf·ft)
PAD SPRING
HYDRAULIC BRAKE
PAD RETAINER
CALIPER BRACKET
BRACKET PIN
12 N·m (1.2 kgf·m, 9 lbf·ft)
BRAKE PADS
19-27