Ecm (Nc700X/Xa/S/Sa) / Pcm (Nc700Xd/Sd) - Honda NC700XA Service Manual

dummyhead dummyhead
ECM (NC700X/XA/S/SA)/PCM
(NC700XD/SD)
REMOVAL/INSTALLATION (NC700X/
XA/S/SA)
Remove the shroud/side cover (NC700X/XA) (page 2-
14).
Remove the side cowl (NC700S/SA) (page 2-13).
Turn the ignition switch OFF.
Disconnect the ECM 33P (Black) connector [1].
Release the band [2] from the ECM and remove the
ECM from the ECM box.
Installation is in the reverse order of removal.
If the ECM is replaced, perform the Key Registration
Procedures (page 23-6).
REMOVAL/INSTALLATION (NC700XD/
SD)
Remove the luggage box lid/hinge assembly (page 2-
19).
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector [1] and
PCM 33P (Gray) connector [2].
Release the band [3] from the PCM and remove the
PCM from the ECM box.
Installation is in the reverse order of removal.
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-
120)
PGM-FI SYSTEM
[1]
[1]
[3]
[2]
[2]
4-67