Honda NC700XA Service Manual page 410

dummyhead dummyhead
4. VS Sensor Output Line Open Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
VS sensor 3P (Black) connector [1] and PCM 33P
(Black) connector [2] terminals.
Connection: Pink/green – A32
TOOL:
Test probe
Is there continuity?
YES
NO
5. VS Sensor Output Line Short Circuit Inspection
Check for continuity between the wire harness side
VS sensor 3P (Black) connector [1] terminal and
ground
Connection: Pink/green – Ground
Is there continuity?
YES
NO
6. VS Sensor Inspection
Turn the ignition switch OFF.
Replace the VS sensor with a known good one
(page 22-18).
Erase the DTCs (page 12-13).
Test-ride the motorcycle and stop the engine.
Check the DTC with the HDS pocket tester.
Is DTC 66-1 indicated?
YES
NO
DTC 67-1 (FRONT WHEEL SPEED
SENSOR NO SIGNAL)
• Before starting the inspection, check for loose or
poor contact on the front wheel speed sensor 2P
(Blue), ABS modulator 25P and PCM 33P (Black)
connectors, and recheck the DTC.
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. DTC Recheck
Erase the DTCs (page 12-13).
Test-ride the motorcycle above 18 km/h (11 mph).
Stop the engine.
Check the DTC with the HDS pocket tester.
Is DTC 67-1 indicated?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
07ZAJ-RDJA110
– GO TO STEP 5.
– Open circuit in the Pink/green wire
– Short circuit in the Pink/green wire
– GO TO STEP 6.
– Replace the PCM with a known good one,
and recheck.
– Faulty original VS sensor
– GO TO STEP 2.
– Intermittent failure
[2]
A32
[1]
[1]
P/G
P/G
12-55