Honda NC700XA Service Manual page 133

dummyhead dummyhead
MAINTENANCE
SERVICE INFORMATION
MAINTENANCE
GENERAL
• Place the motorcycle on level surface before starting any work.
• Gasoline is extremely flammable and is explosive under certain conditions.
• Work in a well ventilated area. Smoking or allowing flames or sparks in the work area or where the gasoline is stored can cause
a fire or explosion.
• The exhaust contains poisonous carbon monoxide gas that may cause loss of consciousness and may lead to death. Run the
engine in an open area or with an exhaust evacuation system in an enclosed area.
TORQUE VALUES
ITEM
Air cleaner housing cover screw
Spark plug
Valve adjusting screw lock nut
Camshaft maintenance cap
Timing hole cap
Crankshaft hole cap
Engine oil drain bolt
Engine oil filter cartridge
Oil filter boss
Rear axle nut
Drive chain adjuster lock nut
Drive sprocket bolt
Driven sprocket nut
Master cylinder reservoir cover
screw
Rear brake reservoir mounting bolt
Rear master cylinder push rod lock
nut
Parking brake adjuster bolt lock
nut (NC700XD/SD)
Sidestand pivot bolt
Sidestand pivot nut
Sidestand switch bolt
3-2
THREAD
Q'TY
DIA. (mm) N·m (kgf·m, lbf·ft)
6 5
2 14
8 7
1 36
1 14
1 30
1 12
1 20
1 20
1 18
2 8
1 10
5 12 108 (11.0, 80)
4 4
1 6
1 8
1 8
1 10
1 10
1 6
TORQUE
1.1 (0.1, 0.8)
22 (2.2, 16)
14 (1.4, 10) Apply engine oil to the threads and
seating surface.
4.0 (0.4, 3.0) See page 3-12
10 (1.0, 7) Apply grease to the threads.
15 (1.5, 11) Apply grease to the threads.
30 (3.1, 22)
26 (2.7, 19) Apply engine oil to the threads.
– See page 3-14
Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) from tip
98 (10.0, 72) U-nut
21 (2.1, 15)
54 (5.5, 40)
U-nut
1.5 (0.2, 1.1)
10 (1.0, 7)
17 (1.7, 13)
17 (1.7, 13)
– See page 3-27
Apply grease to the sliding surface.
39 (4.0, 29) U-nut
10 (1.0, 7) ALOC bolt; replace with a new one.
REMARKS