Honda NC700XA Service Manual page 501

dummyhead dummyhead
CRANKCASE/TRANSMISSION/BALANCER
Remove the shift drum [1] and shift drum bearing [2].
INSPECTION
SHIFT DRUM/SHIFT FORK
Check the shift fork guide pin for abnormal wear or
damage.
Measure the shift fork I.D.
SERVICE LIMIT: 12.03 mm (0.474 in)
Measure the shift fork claw thickness.
SERVICE LIMIT: 5.9 mm (0.23 in)
Measure the shift fork shaft O.D.
SERVICE LIMIT: 11.95 mm (0.470 in)
Inspect the shift drum guide grooves for abnormal wear
or damage.
Turn the outer race of the shift drum bearing with your
finger.
The bearing should turn smoothly and quietly.
Also check that the inner race of the bearing fits tightly
on the shift drum.
Replace the bearing if the inner race does not turn
smoothly, quietly, or if the inner race fits loosely on the
shift drum.
14-10
[1] [2]