Honda NC700XA Service Manual page 380

dummyhead dummyhead
2. Shift Spindle Angle Sensor Ground Line Open
Circuit Inspection
Turn the ignition switch OFF.
Disconnect the shift spindle angle sensor 3P (Gray)
connector.
Turn the ignition switch ON.
Measure the voltage between the wire harness side
shift spindle angle sensor 3P (Gray) connector [1]
terminals.
Connection: Yellow/red (+) – Green/yellow (–)
Is the voltage within 4.75 – 5.25 V?
YES
NO
3. Shift Spindle Angle Sensor System Inspection
Replace the shift spindle angle sensor with a known
good one (page 12-116).
Connect the shift spindle angle sensor 3P (Gray)
connector.
Turn the ignition switch ON.
Check the shift spindle angle sensor with the HDS
pocket tester.
Is about 5 V indicated?
YES
NO
DTC 22-1 (SHIFT SPINDLE
OPERATION MALFUNCTION: AFTER
OPERATING GEARSHIFT
MECHANISM)
1. Shift Spindle Angle Sensor System Inspection
Check the shift spindle angle sensor with the HDS
pocket tester.
Is Low voltage (about 0 V) or High voltage (about
5 V) indicated?
YES
NO
2. Shift Control Motor/Reduction Gear Condition
Check the shift control motor and reduction gears
are installed properly and are not damaged.
Are the shift control motor and reduction gears
in normal condition?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
– GO TO STEP 3.
– Open circuit in the Green/yellow wire
– Replace the PCM with a known good one,
and recheck.
– Faulty shift spindle angle sensor
– • About 0 V: See DTC 21-1 (page 12-23).
• About 5 V: See DTC 21-2 (page 12-24).
– GO TO STEP 2.
– GO TO STEP 3.
– Install the shift control motor and reduction
gears properly or replace faulty parts.
[1]
G/Y Y/R
12-25