Table of Contents
Advertisement
dummyhead
dummyhead
CAMSHAFT
REMOVAL
Remove the engine.
– NC700X/XA/S/SA (page 16-5)
– NC700XD/SD (page 16-9)
Loosen the water hose band screw [1] and disconnect
the water bypass hose.
Remove the bolts [2], water pump [3] and O-rings [4].
Remove the rocker arm (page 10-8).
Release the cam chain tension (page 10-11).
Loosen the cam sprocket bolt [1] by holding the
flywheel mounting bolt and remove it.
Remove the cam sprocket bolt and cam sprocket [2] by
removing the cam chain [3] from the cam sprocket.
Attach a piece of wire to the cam chain to prevent it
from falling into the crankcase.
Remove the camshaft [1].
INSPECTION
CAMSHAFT
Check the cam and journal surfaces of the camshaft for
scoring,
lubrication.
Support both sides of the camshaft (at journals) with V-
blocks and check the camshaft runout with a dial
gauge.
SERVICE LIMIT: 0.04 mm (0.002 in)
scratches
or
evidence
[3]
[1]
of
insufficient
CYLINDER HEAD/VALVES
[1]
[2]
[4]
[2]
[3]
[1]
10-13
Advertisement
Table of Contents
Troubleshooting
