Honda NC700XA Service Manual page 660

dummyhead dummyhead
Remove the bolts [1], holder [2] and master cylinder [3].
Installation is in the reverse order of removal.
• Install the master cylinder holder with the "UP" mark
[4] facing up.
• Align the end of the master cylinder with the
handlebar punch mark.
• Tightening the front master cylinder holder bolts,
upper bolt first, then the lower bolt to the specified
torque.
• Replace the sealing washers with new ones.
• Install the brake hose eyelet joint against the master
cylinder stopper.
TORQUE:
Front master cylinder holder bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
Brake hose oil bolt:
34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill the reservoir to the upper level and bleed the front
brake system:
– NC700X/S (page 19-9)
– NC700XA/XD/SA/SD (page 19-12)
HYDRAULIC BRAKE
[3]
Align [4]
[2]
[1]
19-21