Clutch Switch; Neutral Switch; Side Stand Switch - Honda C8R600F4 Service Manual

CLUTCH SWITCH
Disconnect the clutch switch wire connectors and
check for continuity between the switch termi-
nals.
There should be continuity with the clutch lever
squeezed and no continuity with the lever re-
leased.
NEUTRAL SWITCH
INSPECTION
Disconnect the neutral switch wire connector.
Check for continuity between the switch terminal
am.I trngir11::1 yruum.I.
There should be continuity with the transmission
in neutral, and no continuity with the transmis-
sion in gear except neutral.
REMOVAL/INSTALLATION
Disconnect tho noutrol switch wire connector.
Remove the neutral switch from the crankcase.
Install the neutral switch with a new sealing wash-
er and tighten it.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf.ft)
Connect the neutral switch wire connector.
SIDE ST AND SWITCH
Remove the left side fairing (page 2-2).
INSPECTION
f)isr.nnnP.d the sicie stand switch 2P (green) connec-
tor.
Check for continuity between the connector termi-
nals.
There should be continuity with the side stand
retracted and no continuity with the side stand low-
ered.
LIGHTS/METERS/SWITCHES
19-15