Honda NC700XA Service Manual page 507

dummyhead dummyhead
CRANKCASE/TRANSMISSION/BALANCER
SHIFT DRUM/SHIFT FORK
Apply engine oil to the shift drum bearing [1].
Install the shift drum [2] and shift drum bearing into the
lower crankcase.
The shift forks have the following identification marks:
– "L" mark [1]: left shift fork
– "C" mark [2]: center shift fork
– "R" mark [3]: right shift fork
Apply molybdenum oil solution to the shift fork guide
area and guide pin.
Apply molybdenum oil solution to the shift fork shaft
outer surface.
Install the shift forks [1] into the shift drum guide
grooves with the identification marks facing toward the
right side of the engine and insert the fork shaft [2].
Apply locking agent to the shift drum bearing set plate
bolt threads (page 14-6).
Install the set plate [1] and shift drum bearing set plate
bolts [2].
Tighten the shift drum bearing set plate bolts to the
specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the mainshaft/countershaft (page 14-15).
Assemble the crankcase (page 14-28).
14-16
[2]
[1] [2]
[1]
[2]
[1]
[3]
[2]
[1]