Exhaust Pipe - Honda NC700XA Service Manual

dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM

EXHAUST PIPE

REMOVAL
Remove the lower cowl (page 2-28).
Disconnect the O
Release the O
radiator reserve tank guide [3].
Remove the bolt [1] and disconnect the ground wire [2].
Loosen the exhaust pipe mounting nut [3].
Remove the exhaust pipe joint nuts [4].
Remove the exhaust pipe mounting nut, bolt [5],
washers [6] and exhaust pipe [7].
Remove the exhaust pipe gasket [8].
INSTALLATION
Install a new exhaust pipe gasket [1] to the exhaust port
of the cylinder head.
Install the exhaust pipe and exhaust pipe joint nuts [2]
but do not tighten yet.
Install the exhaust pipe mounting bolt [1], washers [2]
and nut [3] but do not tighten yet.
Install the ground wire [4] and bolt [5] but do not tighten
yet.
Route the ground wire properly (page 1-25).
2-34
sensor 1P (Black) connector [1].
2
sensor wire from the clamp [2] and
2
[1]
[7] [1]/[2]
[5]/[6] [3] [8]
[1]
[1]/[2]/[3]
[2] [3]
[4]
[2]
[4]/[5]