Table of Contents
Advertisement
dummyhead
dummyhead
REAR WHEEL/SUSPENSION
Install the brake caliper/bracket assembly [1] to the
swingarm.
Align the bracket groove with swingarm tab.
Install the rear wheel in the swingarm aligning the brake
Be careful not to
disc between the brake pads.
damage the brake
pads.
Install the drive chain [1] over the driven sprocket.
Apply a thin coat of grease to the rear axle outer
surface.
Install the rear axle [2] from the left side through the
axle adjusting plate [3], swingarm, rear wheel and
collars.
Install the adjusting plate, washer [4] and rear axle nut
[5].
Tighten the rear axle nut to the specified torque.
TORQUE: 98 N·m (10.0 kgf·m, 72 lbf·ft)
Adjust the drive chain slack (page 3-16).
Install the rear wheel speed sensor [1] and bolts [2].
NC700XA/XD/SA/
Tighten the bolts securely.
SD:
Check the air gap between the rear wheel speed sensor
and pulser ring (page 20-24).
Check the parking brake lock operation (page 3-24).
NC700XD/SD:
18-12
NC700XA/SA shown:
[1]
NC700XD/SD:
[1]
[2]
[1]
[3]
NC700XA/XD/SA/SD:
[1]
[2]
Align
Align
[5]
[4]
[3]
Advertisement
Table of Contents
Troubleshooting
