Primary Drive Gear/Ckp Sensor Rotor - Honda NC700XA Service Manual

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
Remove the 6 mm socket bolt [1] to free the primary
drive gear and sub-gear [2].
Install the right crankcase cover (page 12-103).
PRIMARY DRIVE GEAR/CKP SENSOR
ROTOR
REMOVAL
Remove the right crankcase cover (page 12-97).
Hold the primary drive gear and sub-gear with a 6 mm
socket bolt (page 12-105).
Install the special tool between the primary drive and
driven gears, and loosen the primary drive gear bolt [1].
TOOL:
Gear holder, M2.5 [2]
Remove the primary drive gear bolt, washer [3], CKP
Do not separate the
sensor rotor [4] and primary drive gear/sub-gear [5]
sub-gear from the
from the crankshaft.
primary drive gear
unless necessary.
INSTALLATION
Install the primary drive gear/sub-gear [1] and CKP
sensor rotor [2] onto the crankshaft by aligning their
wide grooves with the wide tooth.
Apply engine oil to the primary drive gear bolt threads
and seating surface.
Install the washer [1] and primary drive gear bolt [2].
Install the special tool between the primary drive and
driven gears, and tighten the primary drive gear bolt.
TOOL:
Gear holder, M2.5 [3]
TORQUE: 93 N·m (9.5 kgf·m, 69 lbf·ft)
Remove the 6 mm socket bolt [4] to free the primary
drive gear and sub-gear.
Install the right crankcase cover (page 12-103).
12-108
07724-0010100
07724-0010100
[2]
[1]
[4] [2] [3]
[2]
Align
[2] [1]
[3] [4]
[5]
[1]
[1]