Honda NC700XA Service Manual page 448

dummyhead dummyhead
2. DTC Recheck 2
Erase the DTCs (page 12-13).
Test-ride the motorcycle above 18 km/h (11 mph)
for more than 30 seconds.
Stop the engine.
Read the DTC with the shift indicator (page 12-13).
Is DTC 71 or 72 indicated?
YES
NO
DTC 84 (CPU IN THE PCM
MALFUNCTION)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. DTC Recheck
Erase the DTCs (page 12-13).
Read the DTC with the shift indicator (page 12-13).
Is DTC 84 indicated?
YES
NO
DTC 1 (SHIFT PEDAL ANGLE SENSOR
(OPTIONAL) MALFUNCTION)
• Before starting this inspection, check for loose or
poor contact on the shift pedal angle sensor 3P
(Black) connector and PCM 33P (Gray) connector
and recheck the MIL.
• If the PCM is replaced, perform the following
procedure.
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
– DCT Shift Pedal (Optional) Registration (page 12-
118)
• If the DCT shift pedal (optional) is removed from the
vehicle, perform the DCT Shift Pedal Registration
Cancellation (page 12-119).
1. DTC Recheck
Erase the DTC's (page 12-13).
Turn the ignition switch ON and engine stop switch
" ".
Operate the DCT shift pedal up and down several
times with the engine stopped.
Recheck the DTC with the shift indicator (page 12-
13).
Is the DTC 1 indicated?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
– Replace the PCM with a known good one,
and recheck.
– Intermittent failure
– Replace the PCM with a known good one,
and recheck.
– Intermittent failure
– GO TO STEP 2.
– Intermittent failure
12-93