Honda NC700XA Service Manual page 556

dummyhead dummyhead
Disconnect the linear solenoid valve 4P (Green)
connector [1] and shift spindle angle sensor 3P (Gray)
connector [2] and remove them from the ABS
modulator stay.
Release the fuel feed hose [3] from the clamp [4].
Disconnect the following:
– Inner mainshaft sensor 3P (Black) connector [1]
– Outer mainshaft sensor 3P (Black) connector [2]
Release the rubber cap [1].
Remove the starter motor terminal nut [2] and
disconnect the starter motor cable [3].
Remove the starter motor mounting bolt [4] and
disconnect the ground cable [5].
Release the fuel feed hose [6] from the clamp [7].
Remove the drive sprocket bolt [1], washer [2] and drive
sprocket [3].
ENGINE REMOVAL/INSTALLATION
[1]
[2] [4]
[2]
[2]/[3] [7]
[1]
[3]
[1]
[3]
[1]
[4]/[5] [6]
[2]
16-13