Neutral Switch - Honda CBR650F Service Manual

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
CLUTCH SWITCH
Disconnect the clutch switch connectors [1] and check
for continuity between the switch terminals.
There should be continuity with the clutch lever
squeezed, and no continuity when the clutch lever is
released.

NEUTRAL SWITCH

INSPECTION
Disconnect the neutral switch wire (page 21-18).
Check for continuity between the switch terminal and
engine ground.
There should be continuity with the transmission in
neutral, and no continuity when the transmission is in
gear except neutral.
REMOVAL/INSTALLATION
Remove the pinch bolt [1].
Release the gearshift arm [2] from the gearshift spindle.
Disconnect the neutral switch 1P (White) connector [1].
Remove the neutral switch [2] and sealing washer [3].
Installation is in the reverse order of removal.
• Replace the sealing washer with a new one.
• Align the slit in the gearshift arm with the punch
mark on the spindle.
TORQUE:
Neutral switch: 12 N·m (1.2 kgf·m, 9 lbf·ft)
21-18
CBR650F/FA shown:
[1]
[1]
Align
[2]
[3]
[2]
[1]