Engine Removal (Nc700Xd/Sd) - Honda NC700XA Service Manual

dummyhead dummyhead
Support the engine using a jack or other adjustable
The jack height
support to ease of engine hanger bolts removal.
must be continually
adjusted to relieve
Remove the upper engine hunger bolts [1] and collar
stress for ease of
[2].
bolt removal.
Remove the front lower hunger bolts [1] and collars [2].
Remove the rear engine hunger nuts [1], collars [2] and
bolts [3].
Carefully maneuver the engine and remove it out of the
frame to the right.
During engine removal, hold the engine securely and
be careful not to damage the frame and engine.

ENGINE REMOVAL (NC700XD/SD)

Drain the engine oil (page 3-13).
Drain the coolant (page 8-6).
Fully slacken the drive chain (page 3-17).
Relieve the fuel pressure and disconnect the quick
connect fitting from the fuel injector side (page 7-4).
Remove the following:
– Left rear cover (page 2-30)
– Guard pipe (page 2-30)
– Center cross plate (page 2-32)
– Exhaust pipe/muffler (page 2-32)
– Radiator (page 8-9)
– Radiator reserve tank (page 8-14)
– Throttle body (page 7-15)
Disconnect the CKP sensor 2P (Red) connector [1] and
release the CKP sensor harness.
ENGINE REMOVAL/INSTALLATION
Left side: Right side:
[1] [1]
Left side: Right side:
[1] [2] [2]
Left side: [3] Right side:
[2] [1]
[2]
[3] [1]
[1]
[2]
[1]
[2]
16-9