Shift Spindle Angle Sensor - Honda NC700XA Service Manual

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
Remove the wire band [1] and release the wires and
hose from the stay [2].
Remove the bolt [1], wire clip stay [2] and TR sensor [3].
Remove the O-ring [4] from the TR sensor.
Installation is in the reverse order of removal.
• Replace the O-ring with a new one.
• Apply engine oil to a new O-ring.
• Align the flat surfaces of the TR sensor and shift
drum end.
TORQUE:
TR sensor bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)

SHIFT SPINDLE ANGLE SENSOR

REMOVAL/INSTALLATION
Remove the following:
– Shroud/side cover (NC700XD) (page 2-14)
– Side cowl (NC700SD) (page 2-13)
– Right engine side cover (page 2-30)
Disconnect the shift spindle angle sensor 3P (Gray)
connector [1] and remove it from the ABS modulator
stay.
Remove the bolts [1] and clamps [2].
Remove the bolts [3] and wire clip stay [4].
Remove the shift spindle angle sensor wire clip [5] from
the clip stay.
Remove the shift spindle angle sensor bolt [6] and shift
spindle angle sensor [7].
12-116
[1]
[3] [1]
[2] Align
[1]
[1]/[2]
[7]
[6] [3]/[4]
[2]
[4]
[5]