dummyhead
dummyhead
CLUTCH SWITCH
Disconnect the clutch switch connectors [1].
There should be continuity with the clutch lever [1]
applied, and there should be no continuity when the
clutch lever is released.
NEUTRAL SWITCH
INSPECTION
Remove the right side cover (page 2-2).
Disconnect the neutral switch wire connector [1].
Shift the transmission gear into neutral.
Check for continuity between the Light Green/Red
terminal and body ground.
There should be continuity.
REMOVAL/INSTALLATION
Remove the following:
– Right side cover (page 2-2)
– Drive sprocket cover (page 2-5)
Remove the neutral switch (Light green/red) wire
connector [1] from the boot, then disconnect it.
LIGHTS/METER/SWITCHES
[1]
[1]
[1]
[1]
18-9