Honda NC700XA Service Manual page 324

Hide thumbs Also See for NC700XA:
Table of Contents

Advertisement

dummyhead
dummyhead
Turn the crankshaft clockwise and align the index lines
[1] with the crankcase matting surface, while the "TOP"
mark [2] is facing down.
Make sure the " " mark [1] on the cam sprocket facing
the lower cylinder head index line [2].
If the " " mark on the cam sprocket is facing the upper
cylinder head index line [3], turn the crankshaft
clockwise one full turn (360°) and realign the " " mark
with the lower cylinder head index line.
Remove the cam chain tensioner (page 10-12).
Insert the gear holder [1] between the primary drive
gear and driven gear.
TOOL:
Gear holder, 2.5
Remove the cam sprocket bolt [2].
Remove the cam sprocket [3] by removing the cam
chain [4] from the cam sprocket.
Attach a piece of wire to the cam chain to prevent it
from falling into the crankcase.
NC700X/XA/S/SA:
[2]
NC700XD/SD:
[2]
[1]
07724-0010100
CYLINDER HEAD/VALVES
[1]
[1]
[3]
[2]
[1]
[2]
10-17
Align
Align
[4]
[3]

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nc700xNc700sdNc700xdNc700sNc700sa

Table of Contents