Honda NC700XA Service Manual page 458

dummyhead dummyhead
Install the snap ring [1] into the right crankcase cover
groove with the chamfered edge facing in.
Install the right crankcase cover (page 12-103).
INSTALLATION
Coat new O-rings [1] with engine oil and install them
Do not allow dust or
onto the oil joint pipe [2].
dirt to enter the oil
passages.
Install the oil joint pipe into the oil pump.
Install the dowel pins [1].
Apply engine oil to new seal rings [2] and install them
into the mainshaft grooves.
Push in the seal rings to seat them into the grooves.
Clean the right crankcase cover mating surfaces
thoroughly.
Apply liquid sealant (Three Bond 1207B or equivalent)
to the right crankcase cover mating surface as shown.
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
[1]
[2]
[1]
[2]
12-103
[1]