System Inspection With Hds Pocket Tester; System Inspection With Ecm Test Harness - Honda NC700XA Service Manual

dummyhead dummyhead
PGM-FI SYSTEM
SYSTEM INSPECTION WITH HDS
POCKET TESTER
Connect the HDS pocket tester (page 4-12).
Remove the bank angle sensor (page 4-65).
Connect the bank angle sensor 2P (Black) connector.
Place the bank angle sensor is horizontal as shown.
Turn the ignition switch ON and engine stop switch " ".
Read the voltage with the HDS pocket tester.
STANDARD: 7.0 – 8.8 V
Incline the bank angle sensor approximately 60° to the
left or right with keeping the ignition switch ON.
Read the voltage with HDS pocket tester.
STANDARD: 0.40 – 0.84 V
SYSTEM INSPECTION WITH ECM
TEST HARNESS
Connect the ECM test harness to the ECM/PCM 33P
connector(s).
– NC700X/XA/S/SA (page 4-13)
– NC700XD/SD (page 4-14)
Remove the bank angle sensor (page 4-65).
Connect the bank angle sensor 2P (Black) connector.
Place the bank angle sensor horizontal as shown.
Turn the ignition switch ON and engine stop switch " ".
Measure the output voltage at the ECM test harness [1]
terminals.
CONNECTION:
NC700X/XA/S/SA:
21 (+) – 6 (–)
NC700XD/SD:
B21 (+) – B6 (–)
STANDARD: 7.0 – 8.8 V
Incline the bank angle sensor approximately 60° to the
left or right with keeping the ignition switch ON and
engine stop switch " ".
Measure the output voltage at the ECM test harness
terminals.
CONNECTION:
NC700X/XA/S/SA:
21 (+) – 6 (–)
NC700XD/SD:
B21 (+) – B6 (–)
STANDARD: 0.40 – 0.84 V
4-66
60° BANK ANGLE POSITION
approximately 60°
HORIZONTAL
approximately 60°
[1]
6 or B6
60° BANK ANGLE POSITION
approximately 60°
HORIZONTAL
approximately 60°
21 or B21