dummyhead
dummyhead
5. Shift Pedal Angle Sensor Output Line Short
Circuit Inspection
Check for continuity between the wire harness side
shift pedal angle sensor 3P (Black) connector [1]
and ground.
Connection: Yellow/violet – Ground
Is there continuity?
YES
NO
6. Shift Pedal Angle Sensor Resistance Inspection
Measure the resistance at the sensor side shift
pedal angle sensor 3P (Black) connector [1]
terminals.
Connection: Yellow/red – Blue/green
Standard:
Operate the DCT shift pedal to check that the
resistance changes in accordance with the pedal
operation.
Connection: Yellow/blue – Blue/green
When moving the pedal up:
Resistance increases
When moving the pedal down:
Resistance decreases
Are the resistance inspections normal?
YES
NO
MODE/SHIFT INDICATOR CIRCUIT
TROUBLESHOOTING
If the mode indicator does not operate, check that the
combination meter shows following when the ignition
switch is turned ON with the engine stop switch " ".
– MIL [1] and engine oil pressure indicator [2] stay on.
– Shift indicator "–" [3] is blinking.
– Tachometer, high coolant temperature indicator and
HISS indicator do not come on.
If so, check the TXD/RXD line (page 22-11).
If not so, replace the combination meter.
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
– Short circuit in Yellow/violet wire
– GO TO STEP 6.
4 – 6 kΩ (20°C/68°F)
– Replace the PCM with a known good one,
and recheck.
– Faulty shift pedal angle sensor, replace the
DCT shift pedal as an assembly.
[1]
Y/V
[1]
Y/R
Bu/G
Y/Bu
Bu/G
[1]
[2]
[3]
12-95