Honda NC700XA Service Manual page 649

dummyhead dummyhead
HYDRAULIC BRAKE
Fill the reservoir with DOT 4 brake fluid from a sealed
Do not mix different
container to the casting ledge [1].
types of fluid. There
are not compatible.
Install the diaphragm [1], set plate [2], reservoir cover
Front brake:
[3] and reservoir cover screws [4], then tighten the
screws to the specified torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Remove the 6 mm nut [1], rear brake reservoir
Rear brake:
mounting bolt [2] and reservoir [3].
Install the diaphragm [4], set plate [5] and reservoir
cover [6].
Install and tighten the cover screws [7] to the specified
torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Install the reservoir and rear brake reservoir mounting
bolt.
Align the reservoir tab [8] with the reservoir stay upper
hole [9].
Tighten the bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
19-10
Front shown:
[1]
Front:
[4]
[3]
Rear: [9]
[1]
[3] [2]
[1]/[2]
[7]
[6]
[5]
[4]
[3] [8] [2]