dummyhead
dummyhead
LUBRICATION SYSTEM
Remove the oil strainer [1] and seal ring [2].
Clean the oil strainer screen and check for damage,
replace it if necessary.
INSTALLATION
Apply engine oil to a new seal ring [1] and install it onto
the oil strainer [2].
Install the oil strainer into the crankcase while aligning
the oil strainer boss with the crankcase groove.
Clean the oil pan mating surface thoroughly.
Apply liquid sealant (Three Bond 1207B or equivalent)
to the oil pan mating surface as shown.
Do not apply more liquid sealant than necessary.
Install the oil pan [1] and bolts [2].
Tighten the bolts in a crisscross pattern in 2 or 3 steps.
Install the exhaust pipe/muffler (page 2-32).
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).
9-12
[2]
[1]
[1]
[2]
[1]
[2]
Align