Honda NC700XA Service Manual page 769

dummyhead dummyhead
IMMOBILIZER SYSTEM (HISS)
Check for continuity between the ECM/PCM 33P
connector [1] terminal and ground at the wire side.
CONNECTION: Blue – Ground
TOOL:
Test probe
There should be no continuity.
REMOVAL/INSTALLATION
Remove the top bridge (page 17-33).
Remove the screws [1] and the immobilizer receiver [2].
Install a new receiver and tighten the screws.
Route the receiver
wire properly (page
Install the top bridge (page 17-38).
1-25).
REPLACEMENT PARTS FOR PROBLEM
Problem
One Key has been
lost, or additional
spare key is
required
All key has been
lost
ECM/PCM is faulty
Immobilizer
receiver is faulty
Ignition switch is
faulty
*Accessory lock is
faulty
*Accessory lock means the luggage box lid lock and seat lock.
23-14
07ZAJ-RDJA110
Transponder Immobilizer
Key receiver
[1]
Bu
[2]
Replacement parts
Ignition
ECM/PCM switch
assembly
[1]
*Accessory
Key set
lock and key