Honda NC700XA Service Manual page 299

dummyhead dummyhead
LUBRICATION SYSTEM
SERVICE INFORMATION
GENERAL
Used engine oil may cause skin cancer if repeatedly left in contact with the skin for prolonged periods. Although this is unlikely
unless you handle used oil on a daily basis, it is still advisable to thoroughly wash your hands with soap and water as soon as
possible after handling used oil.
• This section covers service of the oil pump and oil strainer.
• The oil pump and oil strainer can be serviced with the engine installed in the frame.
• The service procedures in this section must be performed with the engine oil drained.
• When removing and installing the oil pump, use care not to allow dust or dirt to enter the engine.
• If any portion of the oil pump is worn beyond the specified service limits, replace the oil pump as an assembly.
• After the oil pump has been installed, check that there are no oil leaks and that oil pressure is correct.
SPECIFICATIONS
Engine oil NC700X/XA/S/SA
capacity
NC700XD/SD
Recommended engine oil
Oil pressure at engine oil filter
Oil pump rotor (NC700X/XA/S/SA)
Engine oil pump rotor (NC700XD/SD)
Clutch oil pump rotor (NC700XD/SD)
TORQUE VALUE
ITEM
Engine oil filter cartridge
9-4
ITEM
After draining
After draining/
filter change
After
disassembly
After draining
After draining/
filter change
After
disassembly
Tip clearance
Body clearance
Side clearance
Tip clearance
Body clearance
Side clearance
Tip clearance
Body clearance
Side clearance
THREAD
Q'TY
DIA. (mm)
1 20
STANDARD
3.1 liters (3.3 US qt, 2.7 Imp qt)
3.4 liters (3.6 US qt, 3.0 Imp qt)
3.7 liters (3.9 US qt, 3.3 Imp qt)
3.2 liters (3.4 US qt, 2.8 Imp qt)
3.4 liters (3.6 US qt, 3.0 Imp qt)
4.1 liters (4.3 US qt, 3.6 Imp qt)
Honda "4-stroke motorcycle oil" or an
equivalent
API service classification: SG or higher
(except oils labeled as energy conserving
on the circular API service label)
Viscosity: SAE 10W-30
JASO T 903 standard: MA
2
470 kPa (4.8 kgf/cm , 68 psi)
-1
at 5,000 min (rpm)/(80°C/176°F)
0.15 (0.006)
0.15 – 0.21 (0.006 – 0.008)
0.04 – 0.09 (0.002 – 0.004)
0.15 (0.006)
0.15 – 0.21 (0.006 – 0.008)
0.04 – 0.09 (0.002 – 0.004)
0.15 (0.006)
0.15 – 0.21 (0.006 – 0.008)
0.04 – 0.09 (0.002 – 0.004)
TORQUE
N·m (kgf·m, lbf·ft)
26 (2.7, 19) Apply engine oil to the threads.
Unit: mm (in)
SERVICE LIMIT
–
–
–
–
–
–
–
–
0.20 (0.008)
0.35 (0.014)
0.12 (0.005)
0.20 (0.008)
0.35 (0.014)
0.12 (0.005)
–
–
–
REMARKS