Brake Pedal - Honda NC700XA Service Manual

dummyhead dummyhead
Apply 0.4 g (0.01 oz) minimum of silicone grease of
silicone grease to the bracket pin and sleeve sliding
surface.
Install the following:
– Sleeve [1]
– Caliper pin boots [2]
– Bracket pin boot [3]
– Pad spring [4]
– Caliper bracket [5]
Apply locking agent to the parking brake caliper pin bolt
threads.
Install the parking brake caliper pin bolt [1] and tighten it
to the specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)

BRAKE PEDAL

REMOVAL/INSTALLATION
Remove the muffler (page 2-32).
Remove the step holder mounting socket bolts [1] and
right step holder [2].
Unhook the brake light switch spring [1] from the brake
pedal.
Remove and discard the cotter pin [2].
Remove the joint pin [3] and disconnect the push rod
lower joint from the brake pedal [4].
Remove the snap ring [5], washer [6], return spring [7]
and brake pedal.
HYDRAULIC BRAKE
[4]
[3]
[1]
[2]
[1]
[4] [7] [5]/[6]
[5]
[2]
[1]
[1]
[2]
[3]
19-37