Honda NC700XA Service Manual page 658

dummyhead dummyhead
Tighten the rear brake caliper mounting bolt [1] to the
specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Tighten the brake pad pin [2] to the specified torque.
TORQUE: 17 N·m (1.7 kgf·m, 13 lbf·ft)
Operate the brake pedal to seat the caliper pistons
against the pads.
PARKING BRAKE PAD
REPLACEMENT (NC700XD/SD)
Loosen the parking brake pad pins [1].
Remove the brake caliper mounting bolt [1] and caliper
[2] from the bracket.
Remove the parking brake pad pins [1] and pads [2].
Make sure the pad spring is installed in position.
Install new parking brake pads and pad pins.
Install the parking brake caliper and new mounting bolts
and tighten the bolt to the specified torque.
TORQUE: 31 N·m (3.2 kgf·m, 23 lbf·ft)
Tighten the parking brake pad pins to the specified
torque.
TORQUE: 17 N·m (1.7 kgf·m, 13 lbf·ft)
HYDRAULIC BRAKE
[1]
[1]
[1]
[2]
[1]
[2]
[2]
19-19