3-25. Fan Motor Rear Panel Replacement
Outline
Replacement
1. Disconnecting the Harness (CN601/MB-887 Board)
2. Removing the Rear Panel
3. Removing the Fan Motor
4. Installing the Fan Motor
5. Installing the Rear Panel
6. Connecting the Harness (CN601/MB-887 Board)
Note
Adjustment after the fan motor replacement is not required.
Preparation
1. Turn the power off and remove the power cord.
2. Remove the top panel. (Refer to Section 1-1.)
Removal
1. Disconnecting the Harness
(1) Disconnect the harness from the connector
CN601 of the MB-887 board.
(2) Release the harness from the harness
clamper.
2. Removing the Rear Panel
Remove the eight screws and open the rear panel
in the arrow direction.
GY-8240UWD
GY-8240FC
CN601
MB-887
board
Remove the Rear Panel
3-25. Fan Motor Rear Panel Replacement
Harness clamper
Rear panel
B3 x 6
B3 x 6
B3 x 6
3-93