Sony GY-8240UWD Maintenance Manual page 365

Error Code Details
2x6A Retry-over of hunching during search
2x6B Search aborted during CTL/TC retry.
2x78 Fatal state of SV
2x79 SV in independent mode
2x7B Could not execute SV DIAG.
2x94 Abnormal communication with SV CPU
2x96 Abnormal EQ data in NVRAM on DPR-160 board
2x97 Abnormal NVRAM on DPR-160 board
2x98 Could not write data in NVRAM on DPR-160 board.
2x99 NVRAM write time-out on DPR-160 board
2x9A Abnormal temperature sensor on DPR-160 board
2x9B Temperature sensor on DPR-160 board outside normal range
2xFE Exceeded ID specified range.
2xYY Other errors
3x03 Reel shift operation incompleted.
3x04 Cassette compartment operation incompleted.
3x05 Thread operation incompleted.
3x06 Thread FG undetected.
3x07 S and T reels are idling.
3x08 S reel overcurrent
3x09 T reel overcurrent
3x0A Capstan overcurrent
3x0C Detected rotation inconsistency between capstan and reel
(in tape slack direction).
3x0D Detected rotation inconsistency between capstan and reel
(in tape-cut-out direction).
3x0E Excessive S tension
3x12 Drum did not lock.
3x14 Abnormal capstan speed
3x15 Abnormal T reel speed
3x16 Detected rotation inconsistency of reels during threading or unthreading
(in tape slack direction)
3x17 Detected rotation inconsistency of reels during threading or unthreading
(in tape-cut-out direction).
3x1B Undefined command
3x1D Incorrect positional relation among cassette compartment,
threading and reel shift
3x26 Emergency eject was pressed.
Continued to next page
GY-8240UWD
GY-8240FC
5-13. Troubleshooting
Remedy
Unload and clean CTL/TC head.
Clean tape path.
. Replace cassette.
. Replace CT-205 board.
. Replace harness.
Correct according to servo error code.
Replace SV-205 board, IF-780 board.
If cassette is inserted, unload.
If cassette is not inserted, replace SV-205
board.
Replace SV-205 board, FM-75 board.
Replace harness.
Replace DPR-160 board.
Replace FM-75 board.
When emergency eject is pressed just
after power is turned on, cassette can be
removed.
Correct according to SV error code.
Check operations. (Do not use emergency
eject other than during servicing.)
5-149