Sony GY-8240UWD Maintenance Manual page 128

3-11. Capstan Motor Replacement
Removal
1. Removing the W Cleaner Assembly
Remove the W cleaner assembly.
(Refer to steps 1 and 2 in Section 3-5.)
n
To remove the fixing screws of the capstan
motor, remove the W cleaner assembly.
2. Removing the CONFI Head Assembly
Remove the CONFI head.
(Refer to step 3 in Section 3-7.)
3. Opening the SV-205 Board
(1) Put the unit on its left side panel down, and
open the SV-205 board.
(Refer to Section 1-9-8.)
4. Removing the Capstan Motor
(1) Disconnect the harness from the connector on
the capstan motor board.
(2) Remove the two screws while holding the
capstan motor by hand.
n
Be careful not to drop the capstan motor.
Installation
5. Installing the Capstan Motor
(1) Pass a new capstan motor through the hole of
the MD base assembly positioning as shown
in the figure and tighten the two screws.
n
Be careful not to damage the capstan motor
shaft when passing the capstan motor through
the hole of the MD base assembly.
(2) Connect the harness disconnected in (1) of
step 4 to the connector of the capstan motor
board.
3-42
. Upper side
PSW3 x 8
Capstan motor
PSW3 x 8
. Bottom side
Remove/Install the Capstan Motor
Capstan motor board
Harness
GY-8240UWD
GY-8240FC