Sony GY-8240UWD Maintenance Manual page 362

5-13. Troubleshooting
Error Code Details
0050 Not recovered because recovering conditions were not established.
00E0 ROM update error
00F0 Nevertheless that it is not a brand-new tape according to Tele-File
information, there exists no data on the tape.
00FE SCSI board (SCS-28) is installed in GY-8240FC, or FC board (FC-82)
is in the GY-8240UWD.
00YY Other errors
1x10 SYS block is aborted.
1x11 Not matching ID managed by DRV-CPU
1x12 SYS command timed-out.
1x13 Received operating command when no tape.
1x14 SV timed-out during start.
1x15 Sync interruption does not occur.
1x19 FMT command timed-out.
1x1B Command to download from FMT failed.
1x1C Failed in DIAG from FMT.
1x23 Uncorrected error occurred.
1x24 Not locked at IN point.
1x25 Lost lock occurred.
1x26 Failed search.
1x27 Servo did not lock.
1x28 IN-point-set error
1x29 ID dislocation
1x2A LTC was abnormal at IN point.
1x2B Error detected in CTL/TC CONFI.
1x39 Transfer abortion timed-out
1x3A Data ready timed-out.
Continued to next page
5-146
Remedy
. Clean with a cleaning cassette.
. Head cleaning
(Refer to " 2-2-4. Stationary Heads
Cleaning".)
. Recover again setting up Recover Type 2.
. Replace cassette tape.
. Replace DPR-160 board.
. Replace drum.
To update from tape, after cleaning,
update ROM again.
Replace cassette tape.
Replace it with FC-82 board or SCS-28
board.
Check minor error code.
Software error
Replace FM-75 or CT-205 board.
Software error
Replace FM-75 board
Hardware error
Replace SV-205 board or FM-75 board.
Replace FM-75 board.
Software error. Rreplace FM-75 board.
Hardware error. Replace FM-75 board.
Check minor error code.
. Clean with cleaning cassette.
. Head cleaning
(Refer to "2-2-4. Stationary Heads
Cleaning".)
. Replace cassette.
. Replace DPR-160 board.
. Replace drum.
Check minor error code.
Unload and clean CTL/TC head.
Clean tape path.
. Replace cassette.
. Replace CT-205 board.
. Replace harness.
Clean CTL/TC head.
Clean tape path.
. Replace cassette.
. Replace CT-205 board.
. Replace harness.
Software error
Replace FM-75 board.
GY-8240UWD
GY-8240FC