Sony GY-8240UWD Maintenance Manual page 178

3-24. Cassette Compartment Motor Replacement
8. Attaching the Spacer and Worm
(1) Put the boss of the spacer in the hole of the
motor.
(2) Align the with the motor joint, then insert it
worm.
9. Installing the Cassette Compartment
Motor
(1) Position the motor as shown in the figure and
pass the harness through the hole of the
chassis.
(2) Align the * marked portion of the motor with
the * marked portion of the chassis and fit the
motor in the two claws while inserting the
hole of the spacer into the boss of the chassis.
Simultaneously, fit the hub of the worm in
the two claws of the chassis.
(3) Confirm that the motor has been fixed.
10. Applying the Grease
(1) Wipe the grease on the worm and clean it.
(2) Slightly apply the grease to the worm.
11. Connecting the Harness
Connect the harness of the cassette comportment
motor to the connector CN935 on the CL-29
board.
Adjustment after Replacement
12. Checking the Cassette Compartment
Motor Operation
Refer to Section 5-4-13.
(CH03: Cassette Compartment Motor Check.)
n
Perform this check with the cassette compartment
installed in the unit.
3-92
Hole
Boss
Spacer
Worm
Attach the Spacer and Warm
*
Hole
Hooks
Boss
Hub
Attach the Cassette Compartment Motor
Cassette compartment motor
Motor joint
CL-29 board
Connector
(CN935)
Connector
Harness
Hooks
*
Cassette compartment
motor
Label
Spacer
Worm (grease smearing)
GY-8240UWD
GY-8240FC