Sony GY-8240UWD Maintenance Manual page 204

4-6. CTL/TC Head Azimuth Adjustment
Adjustment
8. Adjust the CTL/TC Head Azimuth
(1) Turn the azimuth adjustment screw clockwise
so that the specification is satisfied.
(2) Strike the portions A and B shown in the
figure lightly with the tip of a screwdriver.
Then check that the specification is satisfied.
In case the adjustment is performed
9. Adjust the CTL/TC Head Position
Refer to Section 4-7.
10. Check the CTL/TC Head Height
Refer to Section 4-5.
11. Check the CTL/TC Head Azimuth
Refer to steps 6 and 7 in this section.
4-24
Height adjustment screw
Azimuth adjustment screw
PB CTL
(TP11/FM-75)
A
R-SYNC
(TP16/FM-75)
Spec. : A = 5 ±50 us
CTL/TC Head Azimuth Adjustment
Portion B
Portion A
GY-8240UWD
GY-8240FC