Sony GY-8240UWD Maintenance Manual page 13

5. Hold the cassette compartment at the portions A and
lift up the cassette compartment slightly (by 1 cm).
When the four cassette compartment positioning legs
come off from the four positioning holes on a mechan-
ical deck, shift the cassette compartment backward (by
1 cm) to the position where the cassette lid can be
completely seen when viewed from just above.
6. Hold the cassette compartment at the portions B, then
slowly raise the cassette compartment upward to
remove it.
m
. Being careful not to contact the gear on the right of
the cassette compartment with the chassis, slowly
raise the cassette compartment while slightly sliding
it back-and-forth.
. Never move the cassette compartment to the right
and left. If unnecessary force is applied to right and
left, the gear or part may come off.
. Place the cassette compartment with the cassette lid
up or with cassette compartment positioning legs
down.
(If it is put with the cassette lid down, the flexible
card wire/board might be damaged.)
Cassette compartment
GY-8240UWD
GY-8240FC
A
B
A
1-2. Cassette Compartment Removal/Installation
Installation
7. Place the cassette compartment into the unit in the
direction as shown in the figure (with the cassette lid
down).
n
. Being careful not to contact the gear on the right of
the cassette compartment with the chassis, slowly
insert the cassette compartment into the unit while
slightly sliding it back-and forth.
. Never move the cassette compartment to the right
and left. If unnecessary force is applied to the right
and left, the gear or part may come off.
8. Press the portions C of the cassette compartment as
shown in the figure, and then fit the four positioning
legs into the four positioning holes in the mechanical
deck.
Cassette compartment
Cassette lid
Positioning leg
Flexible card
wire/board
Positioning hole
9. Connect the harness to the connector (CN930) on the
CL-29 board.
10. Reattach the cassette compartment bracket assembly.
11. Reattach the plate MD assembly and the top plate.
C
Gears
CN930
C
Harness
1-3