Sony GY-8240UWD Maintenance Manual page 131

Removal
1. Removing the Reel Table Assembly
(1) Press down the claws of reel table assembly
and slackew the two set screws.
(2) Remove the reel table assembly.
n
When the reel table assembly is removed, a
poly-slider washer for reel table height
adjustment may adhere to it. In this case,
remove the poly-slider washer from the reel
table assembly and return it to the reel motor
shaft.
Installation
2. Installing the Reel Table Assembly
(1) Clean the reel table assembly along the
circumference.
(2) Release the reel brake in the arrow direction
and pass the reel table assembly through the
reel motor shaft.
n
Tighten the two set screws of the reel table
assembly after confirming the reel table
height.
Adjustment after Replacement
3. Confirming the Reel Table Height
Refer to Section 3-12-2.
4. Confirming the Reel Brake Clearance
Refer to Section 3-12-3.
5. Confirming the Reel Brake Release
Amount
Refer to Section 3-12-4.
GY-8240UWD
GY-8240FC
3-12. Reel Table Assembly Replacement and Adjustment
S reel table assembly
Claw
Remove the Reel Table Assembly
S reel table assembly
Reel shift plate
assembly
S reel brake
Install the Reel Table Assembly
3-12-1. Reel Table Assembly Replacement
T reel table assembly
Set screws
T reel table assembly
T reel brake
3-45