Sony GY-8240UWD Maintenance Manual page 157

18. Installing the S Plate Assembly
(1) Insert the pins of the S plate assembly into
the holes of the chassis and tighten the screw
while drawing the assembly clockwise.
n
As the edge of tape cleaner is sharp, use great
care to avoid a hand cut.
(2) Connect the harness (full erase head) to the
connector CN3 of the CT-205 board.
(3) Connect the harness (full erase head) to the
connector of the full erase head board.
n
Fasten the harness (full erase head) by the
harness clamper after installing the W cleaner
assembly.
(4) Connect the harness (tape end sensor) to the
connector of the tape end sensor board and
fasten it in the sensor holder.
19. Installing the Pinch Press Assembly
Install the pinch press assembly.
(Refer to steps 3 and 4 in Section 3-10.)
20. Putting the Unit into the Unthreading
End Mode
21. Installing the S Tension Regulator
Assembly
Install the S tension regulator assembly.
(Refer to step 2 in Section 3-21.)
22. Installing the T Drawer Assembly
Install the T drawer assembly.
(Refer to step 3 in Section 3-23-1.)
23. Confirming the T Drawer Assembly
Operation
Confirm the T drawer assembly operation.
(Refer to step 6 in Section 3-23-1.)
24. Installing the CL Guide Rail
Install the CL guide rail with two screws.
25. Confirming the CL Arm Assembly
Operation
Confirm the CL arm assembly operation.
(Refer to step 3 in Section 3-6.)
GY-8240UWD
GY-8240FC
3-20. Threading Ring Assembly Replacement
Harness (Tape end sensor)
Sensor holder
PWH3 x 8
S plate
assembly
CN3
Install the S Plate Assembly
CL guide rail
B3 x 12
Install the CL Guide Rail
Harness
(Full erase head)
Tape end sensor board
Tape cleaner
CT-205 board
Full erase
head board
B3 x 12
3-71