Sony GY-8240UWD Maintenance Manual page 147

4. Removing the Drive Gear Assembly
Remove the each stop washer to remove the
driving gear (S) assembly and driving gear (T)
assemblies.
5. Removing the Worm Assembly
Remove the two screws to remove the worm
assembly.
Installation
6. Installing the Worm Assembly
(1) Wipe off grease from a new worm assembly
and clean it.
(2) Apply grease on the worm gear of the worm
assembly.
(3) Align the positioning hole of the worm
assembly with the positioning pin of the MD
base assembly and fix it with the two screws.
7. Installing the Drive Gear Assembly
(1) Pass the driving gear (S) and (T) assemblies
on the shafts of the MD base assembly
respectively.
(2) Engage the marked portions of both driving
gear (S) and (T) assemblies with the same
groove of the worm gear.
(3) Fix the driving gear (S) and (T) assemblies
with a new stop washer.
8. Installing the Motor Holder Assembly
Install the motor holder assembly.
(Refer to step 4 in Section 3-15.)
9. Installing the PA Guard
Install the PA guard.
(Refer to step 5 in Section 3-15.)
10. Installing the Reel Motor Plate
Assembly
Install the reel motor plate assembly.
(Refer to steps 5 to 10 in Section 3-14.)
Adjustment after Replacement
11. Confirming the Reel Shift Motor
Operation
(CH02: Reel shift Motor Check)
(Refer to Section 5-4-13.)
GY-8240UWD
GY-8240FC
Stop washer
Driving gear (S) assembly
PWH3 x 8
Worm assembly
Positioning hole
Positioning pin
Driving gear (S) assembly
Worm gear
Installing the Drive Gear Assembly
3-16. Reel Shift Gear Replacement
Driving gear (T) assembly
PWH3 x 8
Driving gear (T) assembly
Mark
3-61