Sony GY-8240UWD Maintenance Manual page 174

3-23. T Drawer Assembly Replacement and Adjustment
3-23-2. Slant Guide Slantness Adjustment
Adjustment
6. Adjusting the Slant Guide Slantness
Adjust the adjustment plate position by turning
the adjustment screw so that specification 3 is
satisfied.
. When the drafting tape on the upper flange
and the tape touch:
Turn the adjustment screw to clockwise
direction.
. When the drafting tape on the lower flange
and the tape touch:
Turn the adjustment screw to counterclock-
wise direction.
7. Rechecking the Tape Running at T
Reel
(1) Unthread the tape.
(2) Set the machine to the F. FWD mode, and
then to the FWD mode about three seconds
later.
(3) Check again that the tape running condition
satisfies specification 3.
If specification 3 is not satisfied, repeat steps
6 and 7.
(4) Apply the locking compound to the adjust-
ment screw.
3-88
Adjusting Slant Guide Slantness
Adjustment plate
Adjustment screw
GY-8240UWD
GY-8240FC