Sony GY-8240UWD Maintenance Manual page 108

3-4. Brush Slip Ring Assembly Replacement
4. Installing the Brush Slip Ring
Assembly
(1) Insert the two screws taken out in (2) of step
2 into the screw holes of the brush slip ring
assembly.
(2) Install the brush slip ring assembly position-
ing as shown in the figure.
(3) Tighten the two screws alternately while
pushing both sides of the flange equally from
above.
Tightening torque: 14.7 x 10
{1.5 kgf.cm}
n
Never apply excessive force to the cover.
5. Connecting the Flexible Card Wire
Connect the flexible card wire into connector
CN2 on the HN-258 board.
3-22
–2
N.m
PSW2 x 16
Brush slip ring assembly
Flexible card wire
_2
Tightening torque : 14.7 x 10
Install the Brush/Slip Ring Assembly
HN-258 board
CN2
N.m {1.5 kgf.cm}
GY-8240UWD
GY-8240FC