Brake Lining Replacement - Sony GY-8240UWD Maintenance Manual

3-13. Brake Lining Replacement

Outline
Replacement
1. Removing the Brake Assembly
2. Installing the Brake Assembly
Adjustment after Replacement
3. Confirming the Reel Brake Clearance (Refer to Section 3-12-3.)
4. Confirming the Reel Brake Release Amount (Refer to Section 3-12-4.)
Note
. When the brake lining is worn, replace the whole blake assembly.
. How to replace the brake lining assembly is the same on the supply and take-up
sides.
Preparation
1. Turn the power off and remove the power cord.
2. Remove the top panel. (Refer to Section 1-1.)
3. Remove the plate MD. (Refer to Section 1-2.)
4. Remove the cassette compartment. (Refer to Section 1-2.)
Removal
1. Removing the Brake Assembly
(1) Unhook the spring put on the reel motor plate
assembly.
(2) Release the claw by pressing in the arrow
direction, then remove the brake assembly.
Installation
2. Installing the Brake Assembly
(1) Pass a new brake assembly through the shaft
of the reel motor plate assembly and fix it
with the claw.
(2) Hook the spring to the reel motor plate
assembly.
Adjustment after Replacement
3. Confirming the Reel Brake Clearance
Refer to Section 3-12-3.
4. Confirming the Reel Brake Release
Amount
Refer to Section 3-12-4.
GY-8240UWD
GY-8240FC
Brake assembly
Claw
Remove/Install the Brake Lining
3-13. Brake Lining Replacement
Reel motor plate assembly
3-51