Sony GY-8240UWD Maintenance Manual page 169

T Drawer Arm Height Adjustment
(1) Remove the Tdrawer assembly.
(Refer to steps 1 and 2.)
(2) Remove the stop washer and poly-slider
washer, then remove the T drawer arm from
the T drawer base.
(3) Remove the spring and poly-slider washer.
(4) Adjust the number of poly-slider washers
(height adjustment).
(5) Install the T drawer arm in the T drawer base
and check that the spec 3 is satisfied.
(6) Pass the poly-slider washer through the shaft,
then fix the T drawer arm by a new stop
washer.
(7) Move the T drawer arm in the vertical
direction. At this time, check that the vertical
play satisfies the specification 4.
If the specification 4 is not satisfied, repeat
steps 1 to 3 until it is satisfied. (Vertical
play adjustment)
1 Remove the stop washer
2 Adjust the number of the poly-slider
washers (vertical play adjustment) at the
lower of the T drawer base.
3 Fix the T drawer arm by the stop washer
and check again that the specification 4 is
satisfied.
GY-8240UWD
GY-8240FC
3-23. T Drawer Assembly Replacement and Adjustment
T drawer arm
Poly-slider washer
(Height adjustment)
Spring
T drawer base
Poly-slider washer
(Vertical play adjustment)
Stop washer
* T drawer arm height adjustment/vertical play adjustment
T drawer arm
A
Spec.3: (height)
A = 36.3 to 36.7 mm
Spec.4: (vertical play)
0.2 mm or less
* When the specification 3 and 4 are not satisfied.
. Poly-slider washer for adjustment
Diameter Thickness
0.13 mm
3.0 mm 0.25 mm
0.5 mm
T Drawer Arm Height Adjustment
3-23-1. T Drawer Assembly Replacement
Part No.
3-701-439-01
3-701-439-11
3-701-439-21
3-83