Sony GY-8240UWD Maintenance Manual page 310

5-6. LOG Mode
21. CTL, LTC Log
A 1
Description of Display
A Refer to the section for SV Lock.
1 CTL status (vL)
Left (v/-): CTL valid information
v: CTL valid
_: When other than above
Valid: CTL pitch is measured in
pinch-on state and it is correct
2
Operating mode status (rE)
Left (r/p): Operation mode information
r: Recording operation
p: Playing back operation
s: Searching operation
3 ID value after compensation (R/P Fix)
This value is used for ID IN and search points after compensation calculated from ID before compen-
sation (converted to raw LTC) and R/P CTL counter.
Compensation (Basic concept): The proceeding way of the CTL counter and raw LTC value are the
4 ID value before compensation (R/P Raw)
Information read from LTC IC
n
When the value can be taken as LTC (example: 28 hours 0A minutes 90 seconds 40 frames), "_1"
will be displayed.
This value however is actually discarded using a different flag.
5-94
2 3 4 5 6 7 8 9 0 !- !=
CTL, LTC Display Screen
Right (L/-): SV lock information
L:
a:
_:
Right (E/-): CTL/LTC REC. Confi. information
o:
E:
same and when these continue for several times (currently 3 times),
the value of the raw LTC is taken as the ID.
Other than this, the value is increased/decreased by the CTL counter.
![ !] !\ !; !'
SV (Both of CTL and AT) locks
CTL locks and AT unlocks
Both of CTL and AT unlock
Confi. Error not detected
Confi. Error detected (during recording only)
GY-8240UWD
GY-8240FC