Sony GY-8240UWD Maintenance Manual page 325

3. BT Bit ignore mode
Sets the BT bit ignore mode.
0: When the BT bit of the LOCATE/READ POSITION command is "1", the check condition is
returned.
1: The BT bit of the LOCATE/READ POSITION command is ignored.
4. Name Server enable mode
Sets the Name Server mode.
0: Mode in which a Name Server function is not used.
1: Mode in which a Name Server function is used.
5. PetaServe mode
Sets the PetaServe mode.
0: Standard specifications
1: The specifications of the following two SCSI commands differ from the standard specifications.
. locate (2Bh) command
When the Byte1 Bit0 (immediate bit) of CDB is "0", the actual locate operation is performed.
(Standard specifications; Only the logical pointer is moved)
. Read Position (34h) command
When the Byte1 Bit4 of CDB is "1", the physical position (ID) of the tape is returned to the
initiator.
(Standard specifications: When the Byte1 Bit4 of CDB is "1", CC: Illegal Request is set.)
6. Report-early warning mode
Sets the report-early warning mode.
0: When operations were performed to the Near EOP area by the Space command, early warning will
be reported.
1: When operations were performed to the Near EOP area by the Space command, early warning will
not be reported.
(However, Report-early warning mode can also be set using the mode select command.)
7. Manual cleaning mode
Sets the cleaning mode.
0: Auto cleaning mode
(This is the mode to automatically clean and to eject the Cleaning tape after insertion.)
1: Manual cleaning mode
(This is the mode by the UNLOAD button or by the command through PSC to clean and to eject
the Cleaning tape.)
8. Manual eject mode
Sets the eject mode when an unsupported cassette is inserted in the GY-8240.
0: Auto eject mode
(This is the mode to automatically eject any Cassette tapes not supported by GY-8240.)
1: Manual eject mode
(This is the mode by the UNLOAD button or by the command through PSC to eject any Cassette
tapes not supported by GY-8240.)
GY-8240UWD
GY-8240FC
5-8. SERVICE Mode
5-109