Sony GY-8240UWD Maintenance Manual page 155

5. Removing the CL Guide Rail
Remove the two screws to remove the CL guide
rail.
6. Removing the Pinch Press Assembly
Remove the pinch press assembly.
(Refer to steps 1 and 2 in Section 3-10.)
7. Removing the S Plate Assembly
(1) Disconnect the harness (full erase head) from
the connector CN3 of the CT-205 board.
(2) Disconnect the harnesses from the connectors
of the full erase head board and tape end
sensor board.
(3) Disconnect the harness (tape end sensor)
from the sensor holder.
(4) Remove the screw to remove the S plate
assembly.
n
As the edge of tape cleaner is sharp, use great
care to avoid a hand cut.
8. Removing the S Tension Regulator
Assembly
Remove the S tension regulator.
(Refer to step 1 in Section 3-21.)
9. Removing the T Drawer Assembly
Remove the T Drawer Assembly.
(Refer to steps 1 and 2 in Section 3-23-1.)
10. Removing the Gear Box Assembly
Remove the gearbox assembly.
(Refer to steps 1 to 3 in Section 3-19.)
GY-8240UWD
GY-8240FC
CL guide rail
B3 x 12
Removing the CL Guide Rail
Harness (Tape end sensor)
Sensor holder
PWH3 x 8
S plate
assembly
CN3
Remove the S Plate Assembly
3-20. Threading Ring Assembly Replacement
B3 x 12
Harness
(Full erase head)
Tape end sensor board
Tape cleaner
CT-205 board
Full erase
head board
3-69